Radial Engineering Tonebone Bassbone V2 Bass Preamp and DI Box 2-DAY DELIVERY!

Description

Radial Engineering
Tonebone Bassbone V2 Bass Preamp and DI Box NEW!
AUTHORIZED DEALER!!!
PRODUCT HIGHLIGHTS
2-Channel Bass Preamp
Drive 2 Basses to Amp or PA
EQ & Volume Control Per Channel
Switchable Effects Loop
Boost/Mute Function
Balanced XLR Output
Amplifier Output
Improving on the design of the original, the
Tonebone Bassbone V2 Bass Preamp and DI Box
from
Radial Engineering
is a 2-channel preamp that allows you to connect 1 or 2 basses to a single amplifier, PA, or recording destination, and also includes a boost function and switchable effects loop. Each channel offers independent level control for matching signals, along with independent EQ to suit different basses or styles. A balanced XLR output lets you connect to a PA or recording interface, while the 1/4" amplifier out allows you to hit your amp simultaneously.
A boost/mute switch allows you to either boost your signal, or mute it entirely. The effects send can be switched on and off, and even includes a blend knob that lets you adjust your wet/dry blend, and can be applied to channel 1 or channel 2, or both. A piezo booster allows you to connect a piezo pickup with no signal loss.
2-channel bass preamp
Built-in Radial DI with low-Z balanced out for the PA
Combination power booster, effects loop, and mute
EQ and level controls for each bass
Audio Circuit Type
Discrete class-A FET input with low noise ICs
Frequency Response
20 Hz to 18 kHz
Total Harmonic Distortion
0.05% @ -15 dBu
Intermodulation Distortion
0.2% @ -20 dBu
Dynamic Range
85 dB
Input Impedance
Input A: 220 kOhms
Input B: 220 kOhms/10 MOhms
Output Impedance
300 ohms @ XLR
Maximum Input
+7 dBu
Gain
Unity gain device
Gain Boost
Gain Boost Drive: 0 to 25 dB
Noise Floor
-100 dB
Equivalent Input Noise
-92 dBu at XLR
High Pass Filter
Flat, 35 Hz and 60 Hz (6 dB/Octave)
XLR Configuration
Pin 2 +, Pin 3 -, Pin 1 Ground
Ground Lift
Lifts pin-1 on the XLR
Power
+15 VDC/400 mA adapter included
Construction
14-gauge steel
Operating Conditions
Use in dry locations only between 41 to 104°F (5 to 40°C)
Dimensions (L x W x D)
5.5 x 4.2 x 2" (203 x 107 x 48 mm)
Weight
2.6 lb (1157 g)